Wahlash Maya

STEP 1: CURL 'EM, GIRL. Curl your lashes with your Wah-Lash Eyelash Curler if needed. STEP 2: MASCARA. Apply a small amount of mascara to your natural lashes prior to placement of your strip to avoid mascara onto your Wah-Lash 3D Mink Eyelash. STEP 3: TRIM 'EM, GIRL. If the lash strips are wider than your eye, trim one side to fit your lash line. You can also trim individual lashes to make them appear more natural. They should be shorter towards the inner corner of the eye and get longer towards the outer eye. For an even more natural look, you can make small "V" cuts into the lashes to make the lengths more natural-looking. STEP 4: GET THE GLUE. Squeeze a small line of eyelash glue onto the back of your hand and run the back of the eyelash seam along the glue. Blow gently from edge to edge to make the glue a little tacky; about 30 seconds or so. You want the glue to start 'setting' before you apply them to your eyelid. STEP 5: GET THE TWEEZERS. Pick the lashes up with your Wah-Lash pointed tweezers and bring the strip as close to your natural lash line as possible. STEP 6: LINE 'EM UP. Line up the outer edge of the lash against the outer edge of your own lashes. Push them into place as close as possible. (You can either use your fingertips or your pointed Wah-Lash tweezers to push into place.) They need to rest close to the roots of the lash. Press them down gently from end to end. Keep a steady hand and DON'T PANIC! Make sure the eyelash is secure on both corners as well as in the center. You can start on either end– just do whichever feels more natural to you. STEP 7: HOLD UP GIRL! WAIT! Wait for approximately 30 seconds to a minute. This allows the glue to 'set.'