Step 1: Start your installation with a 2-clip weft
- Gently brush your hair and extensions to remove any knots or tangles.
- Since clip-in hair extensions are installed from the bottom up, you'll start with a thin section of hair at the nape of your neck.
- Secure the rest of your hair up and away with a hair clip.
- Find the center of the section at your nape and place the 2-clip weft into the teased hair— as close to the roots as possible, pulling the weft tight when securing.
- Snap the clip shut so it grips your hair.
Step 2: Create another parting and install the larger 3-clip weft
- Separate another thin section of hair about an inch above the 2-clip weft and tease close to your roots.
- Find the center of that section and secure the middle clip of the 3-clip weft close to the roots, followed by clipping in the sides.
Step 3: Create another parting and install the 4-clip weft
- An inch above the 3-clip weft, use a 4-clip weft.
- This section should be at the widest part of your head.
- Tease and clip in the middle two clips at the center of the section and continue clipping in the sides.
Step 4: Create another parting and install a 4 or 3-clip weft
- An inch above the first 4-clip weft, use your second 4 or 3-clip (this depends on the length you purchased).
Step 5: Create another parting and install a 3-clip weft
- Separate a thin straight section of hair about two inches below the crown of your head.
- Using the 3-clip weft, find the center and attach the middle clip to the roots of your hair first, followed by the side clips.
Step 6: Create your last parting and install two 2-clip wefts
- Separate a thin straight section of hair about two inches above the ear on each side of your head.
- Take a 2-clip weft and secure the clip closest to your hairline first.
- Then secure the second clip closer to the back of your head.
Step 7: Brush your hair, style and slay — in that order
- Brush your hair and check in the mirror to ensure all the wefts are hidden.
- Adding some waves to your hair always helps everything blend.
- Remember to use a heat-protectant like the Kashmira Heat Protector Serum beforehand!
Hot Tip:
- For an extra-secure hold, lightly tease the hair in the spot where you will clip in the extensions.
Care Instruction:
- Brush the extensions to remove any tangles or knots.
- Fill a basin or sink with lukewarm water.
- Add a small amount of gentle shampoo to the water.
- Soak the extensions in the water for a few minutes.
- Gently massage the shampoo into the extensions, avoiding the clips.
- Rinse the extensions thoroughly with lukewarm water.
- Apply a small amount of conditioner to the extensions, avoiding the clips.
- Leave the conditioner in for a few minutes.
- Rinse the extensions thoroughly with lukewarm water.
- Gently blot the extensions with a towel to remove excess water.
- Hang the extensions to air dry, or use a low heat setting on a hair dryer.
