Unlike traditional skincare application, with Airbrush Skincare and the LUMINESS Active concentration formulas - a little goes a long way.
Start by adding just a few drops of your chosen skincare into the product well at the top of the device and close the lid.
Close your eyes and feel the air coming out of your BREEZE which will guide your application.
Gently pull back on the device trigger to release the serum in mists onto the skin while moving in a circular motion.
Once you’ve completed your application, simply add a few drops of water into the product well, and pull back fully on the trigger to clean your device.
Hyaluronic 2% Serum in Mist
- Directions: Dispense 6 drops into Breeze Airbrush System product well. Pull back trigger to the soft spray setting to dispense mist. Apply an even layer on to skin.
- Usage Frequency: Can be used twice daily, morning and night.
Retinol 1% Serum in Mist
- Directions: Use as part of a daytime routine. Dispense 5 drops into the Breeze Airbrush System product well. Pull back trigger to the soft spray setting to dispense mist. Apply an even layer on to cleansed skin. Use SPF during the use of this product for added protection.
- Usage Frequency: Use at night 3-4x weekly or as tolerated by skin.
Niacinamide 10% Serum in Mist
- Directions: Dispense 10 drops into the Breeze Airbrush product well. Pull back trigger slowly to dispense mist. Move device in circular motions to apply an even layer onto cleansed skin.
- Usage Frequency: Can be used daily, during the morning.
Vitamin C 15% Serum in Mist
- Directions: Dispense 10 drops into the Breeze Airbrush product well. Pull back trigger to the soft spray setting to dispense mist. Move device in circular motions to apply an even layer onto cleansed skin.
- Usage Frequency: Use daily if tolerated well by skin, or every other day in the morning.
- Battery Charging - ENSURE DEVICE IS FULLY CHARGED FOR 4 HOURS BEFORE USE FOR OPTIMAL PERFORMANCE.
- To charge, connect charging cable into a USB charging box.
- Remove silicone stopper from charging port and connect charging cable onto USB charging port on base of device.
- Power button light will blink during charging.
- When indicator light stops blinking and turns on, the system has been fully charged.
- Device battery indicator light will flash red when the batter power has been depleted.
Multi-Speed Setting
- 1- Speed: Press ON/OFF button once to turn device on and activate first speed
- LED light will illuminate solid
- 2-Speed*: Press ON/OFF button twice to turn device to activate two speed
- Both LED lights will illuminate solid
- Clean mode*: Press and hold the ON/OFF button until LED lights turn on or for about 5 seconds
- All LED lights will illuminate and blink
- *Available in select models
How to Clean
- Place eight (8) drops of water or Cleaning Solution into product well. The solution will loosen and dissolve left over makeup or skincare. If you don’t have Cleaning Solution run warm to hot water through your system stylus after each use.
- Activate clean mode* by pressing and holding power button until LED lights turn on for about 5 seconds. Place index finger over airbrush nozzle to block airflow. Gently pull back on airbrush trigger up to the heavy setting so small bubbles appear in product well. Back bubble for 8-15 seconds depending on level of cleaning needed. Back bubbling aerates and clears airbrush makeup or skincare inside the stylus.
- Pull back trigger to heavy setting to flush out product onto a tissue or into a bathroom sink.
- Remove any makeup or skincare from product well with a soft cotton swab. Do not apply excessive pressure to airbrush needle running through bottom of makeup well as this may damage your airbrush stylus.
TIP: To Prevent Clogs & Splattering
- Fill product well half way with Tip Top Cleaning Solution
- Let sit overnight
- Spray out completely before next use